The corrugated pipe production line is controlled by a PLC for the frequency of cylinder movement. Therefore, the internal clock of the PLC can be set to adjust the speed of wire feeding. The wire feeding speed should match the wire winding speed, and there should be sufficient length to allow it to swing freely. When starting up, first press the reset button to return to the initial working position. Then, do not insert the copper wire and run the machine empty to check if the cylinder movements are harmonious. You can appropriately adjust the intake and exhaust of the cylinder to make their movements harmonious. After the empty operation is harmonious, thread on the copper wire, turn on the wire feeding and winding operation knobs, start the wire feeding and winding. When the wound wire can be placed on the wire winding frame, hang the wire on the wire winding reel, and then turn on the wire winding control. When winding the wire, the wire feeding of the PE plastic drainage pipe equipment is accomplished by the movement of the cylinder.

The equipment for the corrugated pipe has occasionally experienced wire winding failure. The reason is that the wire pulling rod did not pull the wire in place, so the wire blocking rod failed to block the copper wire. The fundamental cause of the PE winding reinforced pipe equipment is usually the wire feeding problem. After resolving the wire feeding issue, simply move the copper wire by hand to assist the machine in completing the operation. When winding the wire, since the formed wire bends upward, it brings difficulties to the winding of the wire. At this time, the formed ribbon can be rotated 180 degrees to make the bending arc consistent with the winding axis arc. In this way, a neat copper wire roll can be wound. Paper tapes can also be installed on the paper roll rack and embedded on each layer of ribbons.